How do I know what bathtub cartridge I need?

Use a caliper or ruler and measure the cartridge. Do this by measuring from the base to the tip (from seat to splines). Pay attention to the length tier of your cartridge (Lengths range from 1–12).

Where is the model number on a Kohler faucet?

Identifying Your Faucet Model

The model number is printed on a tag that is attached to the cold water supply line of the faucet.
The supply line is located below the sink, countertop, bath rim, or behind the bowl of a bidet.
The model number, or part number, is typically preceded by “P/N.”

How do I find out what brand my shower cartridge is?

Look at the center of the trim plate behind the shower handle to find a brand name or manufacturer symbol. If you see a “K,” the faucet is a Kohler unit; an “M” signifies Moen. American Standard, Delta and Price Pfister typically print their entire name on the faucet itself.

How do you repair a Kohler bathroom faucet?

– Video: UltraGlide Valve Replacement for Widespread Bathroom Sink Faucets – Replace the Valve in a Two Handle Faucet – Search for articles on how to Remove the Handles for a variety of faucet families

How do you remove a Kohler faucet cartridge?

– TURN OFF WATER. Turning off the water at the shut off valves under the sink. – PRY OFF HANDLE. Pry off the handle cap using a small flat screwdriver. – REMOVE HANDLE FROM ASSEMBLY. – REMOVE THE RETAINING NUT. – REMOVE THE RETAINING CLIP. – REMOVE THE O-RING. – REPLACE THE CARTRIDGE. – REINSTALL THE O-RING.

How do I replace a Kohler bathroom sink faucet cartridge?

Use the shut-off valve underneath the sink to cut off the water supply. Be sure the valve closes completely.

Turn the hot and cold taps on all the way. This lets the water that’s still in the pipes run out into the sink.

Turn off the taps.

Plug the drain. Use the stopper handle on the faucet or a traditional stopper. Even a rag will do in a pinch.

How to install a Kohler bathtub faucet?

Kohler’s set screws can be removed with a 5/32-inch hex key (also called an Allen wrench). With the hex key inserted into the set screw, twist it counterclockwise just enough to loosen the screw’s grip on the pipe. You don’t need to remove the set screw completely. Once the screw is sufficiently loose, the tub spout can be pulled forward until it’s completely off the water pipe.