What are the commands to configure a switch?
Cisco Commands Cheat Sheet
| Basic Configuration Commands | |
|---|---|
| Command | Purpose |
| interface fastethernet/number | Enters interface configuration mode for the specified fast ethernet interface |
| reload | An exec mode command that reboots a Cisco switch or router |
| hostname name | Sets a host name to the current Cisco network device |
What is Cisco show commands?
Cisco show command cheat sheet
| Show option | Meaning |
|---|---|
| show startup-config | Displays configuration saved in NVRAM |
| show running-config | Displays configuration currently running in RAM |
| show spanning-tree | Displays information about the spanning tree state |
| show vlan | Displays VLAN information |
What is the command for switch?
The SWITCH command provides a multipath branch in a program. The specific path taken during program execution depends on the value of the control expression that is specified with SWITCH. You can use a SWITCH statement only within programs.
What is no shut in Cisco?
The no shutdown command enables an interface (brings it up). This command must be used in interface configuration mode. It is useful for new interfaces and for troubleshooting.
What is CLI in Cisco switch?
The Cisco IOS command-line interface (CLI) is the primary user interface used for configuring, monitoring, and maintaining Cisco devices. This user interface allows you to directly and simply execute Cisco IOS commands, whether using a router console or terminal, or using remote access methods.
What is config t?
In privileged mode, you can show anything but not make changes. Next, type config terminal (or config t) to go to global configuration mode (where the prompt looks like router(config)# ). From here, you can change global parameters.
Which command should be used on a Cisco router?
The terminal monitor command is very important to use when log messages appear. Log messages appear by default when a user is directly consoled into a Cisco device, but require the terminal monitor command to be entered when a user is accessing a network device remotely.
What is Cisco console line 0?
The use of “line console 0” command is to connect a switch/router through medium console. If there is only one console port, you can only choose “line console 0”. However if you have more than the number goes as 1,2,3,4 You can set different or same password to all your console ports.
What are the basic commands to configure a Cisco switch?
Cisco Switch Configuration basic commands 1. Changing the hostname of a switch to GfgSwitch : It is used to set the name of the device. switch (config)#hostname… 2. To add a banner message : It provides a short message to the user who wants to access the switch. GfgSwitch… 3. To set IP address
What are the cheat sheets for Cisco switch?
Cisco Switch Commands Cheat Sheet (CLI) 1 Verification Commands: 2 Resetting the Switch. 3 Setting Host Names 4 Setting login credentials: [Sets encrypted secret password using MD5 algorithm. 5 Console Access: 6 SSH/Telnet Access to the switch:
How to configure a new switch?
A switch is a layer 2 device used to forward packet from one device to another within the network. It forwards the packet through one of its ports on the basis of destination MAC address and the entry in the MAC table. Following basic commands are used to configure a new switch : 1. Changing the hostname of a switch to GfgSwitch :
What is a configuration mode command in Cisco?
A configuration mode command that sets this Cisco device password that is required for any user to enter enable mode. service password-encryption. A configuration mode command that directs the Cisco IOS software to encrypt the passwords, CHAP secrets, and similar data saved in its configuration file.