What is deadbolt throw length?
The “throw” of a deadbolt is the length that it extends out of the door edge when engaged. A longer throw makes it more difficult for burglars to gain entry by spreading the doorframe. Most locksmiths recommend a minimum throw of one inch.
Are there different lengths of deadbolts?
In the United States, there are two common backsets for residential door locks: 2 3/8 inches and 2 3/4 inches. Pack your locks with a 2-3/8-inch or 2-3/4-inch latch, depending on which backset you specify.
Are deadbolts solid metal?
On Grade 1 deadbolts the outer trim ring is either a solid machined metal ring or a solid inner ring with an architectural cover. The solid ring provides protection from attack with a hammer and is free-spinning to prevent wrenching the cylinder to gain entry.
Can you adjust a deadbolt?
Failure to adjust the backset results in a lock that does not operate properly or at all. Adjusting the backset ensures the deadbolt locks completely once you install it in the door. Measure the distance from the edge of the door to the center of the hole with a tape measure.
How do I make my deadbolt hole deeper?
This can be corrected by enlarging the bolt pocket or changing the strike plate. To make the bolt pocket deeper, taller or wider, depending on where your bolt is dragging, use a chisel on the bolt hole until it is 1” deep and allows the bolt to fully extend without dragging.
What is a Cays lock?
The Cays 2″ Throw Gate Lock is designed for use with a wooden gate with frames between 30mm and 50mm thick. The lock housing plate is screwed to the frame at the back of the gate and once installed, allows the gate to be locked with a key from the front or back of the gate.
Can you put a Yale lock on a wooden gate?
A Yale lock is unsuitable for use as an external gate lock as it will not weather well. So, what are the best locks for gates?
How do I know what size deadbolt I need?
The backset is the distance from the edge of the door to the center of the 2-1/8-inch bore hole. In the United States, there are two common backsets for residential door locks: 2 3/8 inches and 2 3/4 inches. Pack your locks with a 2-3/8-inch or 2-3/4-inch latch, depending on which backset you specify.
What is a Grade 1 deadbolt?
A secure entry starts with a solid door and a Grade 1 or Grade 2 deadbolt with a solid 1-in. long throw bolt (see “Buying a Deadbolt”). Any exterior door that only has a lock in the doorknob isn’t secure.
How to choose a new deadbolt lock?
Most new locks are adjustable to fit either backset dimension. Just read the box carefully (you may have to open it and read the directions to find the information). Also decide whether to buy a single cylinder (keyed on exterior side of lock only) or a double cylinder deadbolt (keyed on both sides).
How do I know what size deadbolt I Need?
Almost all types are held by two screws on the interior side of the door and two screws on the faceplate (Photo 1). Measure the cylinder hole size and the “backset” distance, that is, the distance from the center of the hole to the door edge (Photo 1). You’ll need these dimensions when you purchase a new deadbolt.
What is the backset distance of a deadbolt lock?
The backset distance is usually either 2-3/8 or 2-3/4 in., so make sure the new deadbolt has the identical backset. Most new locks are adjustable to fit either backset dimension.