How much oil does a Chevy rear end hold?
Engine Oil SAE 5W-30 is preferred. Capacity: 5 quarts.
How often should you change your rear end gear oil?
every 30k to 60k miles driven
Usually, differential fluid is changed after every 30k to 60k miles driven. This is a tough job, so must be handled by an expert technician. Only an experienced mechanic can properly wipe out the old different fluid from your vehicle’s drive-train.
When should I change my differential fluid Silverado?
How Often Should You have the Differential Fluid Changed in Your Chevrolet? Generally speaking, differential fluid should be changed anywhere from every 30,000 miles to 60,000 miles.
How much does differential fluid change cost?
Differential Fluid Change Cost The fluid itself can cost between $30 and $80, and labor will run between $40 and $70. All together, you’re looking at somewhere in the range of $70 to $150 to change your differential fluid depending on your vehicle, where you take it, and how much differential fluid it needs.
How much oil does a 10 bolt Chevy rear end hold?
from Sierra Vista AZ. Little rears like the 7.5 take about 2 qts, larger ones like the 9 inch and Dana 60 take 3 or so. Fill it to within half an inch of the bottom of the fill plug hole, and you should be fine.
How many quarts is a 12 gauge bolt?
Registered. A 12 bolt should only take around 3 quarts until it comes out the fill hole.
Can you use 75w90 instead of 75w85?
Can I safely replace 75W-85 with 75W-90? Our answer: Yes, 75W-85 gear oil can most definitely be replaced by 75W-90.
How do you change the gear oil in a Chevy Silverado?
The gear oil can be easily changed by following the Chevy 10-bolt procedure. Park the car on a flat, level surface and set the parking brake. Jack the rear-end of the car up using the floor jack until the rear axle is high enough to clear the automotive jack stands.
How do you drain the gear oil from the rear differential?
Jack the rear-end of the car up using the floor jack until the rear axle is high enough to clear the automotive jack stands. Place the rear axle on jack stands spaced approximately thirty-two inches on either side of the differential. Place the drain pan beneath the 10 bolt differential to catch the gear oil as it is drained.
What kind of oil to use in rear differential?
I build rear differentials and I always use Conventional Petroleum Based 80-W90 Gear Oil with one bottle of the GM Limited Slip Additive. You will need 2.5 Quarts for a 12 Bolt. This is from Eaton’s website: Eaton Posi units perform best when using GL4 (or better) mineral/petroleum based gear oil.
How do you fill the differential on a Chevy Silverado?
Remove the top fill plug from the differential housing using the 1/2-inch combination wrench. Place small funnel into fill hole now accessible with fill plug removed. Fill rear housing to within 1/2-inch of fill hole. Replace fill plug using 1/2-inch combination wrench and wipe any excess oil from differential.