Why is my GE dishwasher holding water in the bottom?

Why is my GE dishwasher holding water in the bottom?

Water in the bottom of the dishwasher results from clogs in the filter, garbage disposal, drain hose, drain pump, or air gap. When food or sediment build up within these systems, the dishwasher won’t drain properly. Locating the blockage and clearing the debris will solve the problem.

How do you run a diagnostic on a GE dishwasher?

How do I put my GE dishwasher in diagnostic mode? While the dishwasher is in stand-by mode, press and hold down the pads – Cycle + Start – at the same time for about five seconds. The door status will be checked first (for 10 seconds) with other error checks following.

Should there be water sitting in the bottom of my dishwasher?

Water in this area is actually perfectly normal, useful even. It’s there to keep the seals from drying up. It drains when a cycle starts and is replaced with fresh water at the end of the cycle.

How do I troubleshoot a GE dishwasher?

To resolve GE dishwasher starting problems, latch the dishwasher securely until it clicks. Check your electrical box for blown fuses, and reset if blown. Unlock the control panel by pressing and holding the “Heated Dry” button for three seconds. Turn the water valve underneath the sink on.

How do I reset a GE dishwasher?

To reset a GE dishwasher, press the Start or Reset button during a cycle. If you have a top-loading dishwasher, you’ll need to open the top, press the button, and close it again. Then, wait 2 minutes for the dishwasher to pump out the water. After 2 minutes, open the door and add any additional dishes.

Where is fuse on GE dishwasher?

The thermal fuse is normally located on the top side of the circuit board assembly with two wires attached to it. When the thermal fuse fails, the control board will not receive power and the dishwasher will not start.

How do I hard reset my GE dishwasher?

Try pressing the “Start/Reset” pad to reset the dishwasher and wait 2 minutes. If the problem persists, reset (reboot) the dishwasher by turning off power to the unit at the house circuit breaker or fuse box for 30 seconds. Restore power and the dishwasher should reset and function normally.

Why will my GE dishwasher not turn on?

Reset the fuse or circuit breaker in your home that provides power to the dishwasher. For more information, see Dishwasher – Checking Fuse or Dishwasher – Reset Circuit Breaker. The dishwasher may be installed with a power cord that has come loose. Not all dishwashers have a power cord.

https://www.youtube.com/watch?v=96c722z4Uug