How do you clear a blocked Saniflo?

How do you clear a blocked Saniflo?

Firstly, switch off the Saniflo. For now, you may need to remove some of the waste by hand, especially if the waste threatens to overflow. Next, take some hot towels and place them along the length of your waste pipe. This should loosen up the frozen blockage and allow you to flush out the waste.

What should a Saniflo sound like?

The Saniflo macerator is no louder than a toilet flushing. The sound volume emitted in decibels may vary from one installation to another, depending on the product and especially the surroundings (tiled room or not, size and shape of the room, etc.).

Can you plunge a Saniflo?

Things You’ll Need A macerator grinds solid waste into small enough particles that it can travel through your other waste pipes. Because of this, if you get a clog or blockage in your Saniflo, you cannot simply plunge the toilet to unblock it or you may damage the macerator.

Can I put drain Unblocker in a Saniflo?

4 Answers from MyBuilder Plumbers Chemicals should NOT be used on saniflow systems as it can damage the seals inside (nor plunge them), if all else is draining fine then as above check the waste in the shower.

What is a saniplus system?

The Saniplus is a 1/2 HP pump system used to install a complete bathroom up to 15 feet below the sewer line, or even up to 150 feet away from a soil stack. It incorporates a macerating system which can handle human waste and toilet paper in residential applications.

Does saniplus work with a toilet bowl?

However, the Saniplus works as a system and therefore a toilet bowl (seat included with bowl) (083 or 087), toilet tank (005) and the macerating unit (002) need to be purchased. An optional extension pipe (030) is available for the pump to be installed behind the wall. No cabinets, shower nor bathtub are included.

What items do I need to purchase separately from the saniplus?

All items may be purchased separately. However, the Saniplus works as a system and therefore a toilet bowl (seat included with bowl) (083 or 087), toilet tank (005) and the macerating unit (002) need to be purchased. An optional extension pipe (030) is available for the pump to be installed behind the wall.

What size base do I need for my saniplus system?

This base should be made out of a 2″ x 6″ (minimum) or 2” x 8” (recommended) on edge, to allow for the installation of a P-trap and the required 1/4”per foot gravity flow towards the pump unit. The wastewater from other sanitary fixtures is discharged into the Saniplus via two 2-inch inlets on either side of the housing.