What is VAP in WIFI?

What is VAP in WIFI?

Virtual Access Point Settings. Virtual Access Point Settings. VAPs segment the wireless LAN into multiple broadcast domains that are the wireless equivalent of Ethernet VLANs. VAPs simulate multiple APs in one physical AP.

What is a SonicWall virtual access point?

Virtual Access Point is a multiplexed installation of a single physical Access Point (AP) so that it presents itself as multiple discrete Access Points. To wireless LAN clients, each Virtual AP appears to be an independent physical AP, when in actuality there is only a single physical AP.

How do I set up guest WIFI on SonicWall?

Enable Guest Services on the LAN zone

1. Login to the SonicWall management GUI.
2. Navigate to Network | Zone page.
3. Click Configure button for the zone you wish to add Guest Services to.
4. Click Guest Services tab.
5. Enable the check box under Enable Guest Services.
6. The following additional options can be configured.

How do I access my Sonicwall access point?

Step 1: Connect one LAN port on the SonicPoint to a SonicOS appliance interface. Step 2: Login to SonicOS firmware | Navigate to the Network | Interfaces page | click Configure for the interface to which your SonicPoint is connected. Step 3: Configure the interface as following.

How do I create a virtual access point?

1. In the left-hand menu, navigate to the Access Points | Virtual Access Point page.
2. Click the Add…
3. Enter a default name (SSID) for the VAP.
4. Select the VLAN ID you created in “VLAN Sub-Interfaces”section from the drop-down list.
5. Check the Enable Virtual Access Point checkbox to enable this access point upon creation.

What is a virtual SSID?

Enterprise-grade access points have the ability to offer virtual SSID’s, or more than one wireless network name per access point. Virtual SSID’s are commonly used to provide access to different parts of the network, often for different departments.

How do I set multiple Ssids on access point?

How to configure Multi-SSID mode of the Wireless N Access Point (new logo)?

1. Log in the web-based management of the Access Point.
2. Go to Quick Setup and click Next to start.
3. If you want to change your login account, click YES.
4. Select Multi-SSID as Operation Mode.

What is the name of the rule you would create on the SonicWall to require users to authenticate?

Remote Authentication Dial In User Service (RADIUS) is a protocol used by SonicWall security appliances to authenticate users who are attempting to access the network.

How do I set a static route in SonicWall?

Select the following route policy settings:

1. Source = Any.
2. Under Destination = specify Create New Address Object.
3. Enter a name for the static route.
4. Specify the Zone Assignment as LAN.
5. Specify the Type as Network.
6. Specify the IP Address 10.10. 20.0.
7. Specify the Netmask 255.255. 255.0.
8. Click OK.

How do I reset my SonicWall access point?

You can reboot individual access points or groups of access points from the Access Point Objects section on the Device > Access Points > Settings page: Reboot a single object by: Check the checkbox next to the name of the access point to be rebooted. Click Reboot.