What is 100BASE FX meaning?
100BASE-FX is the technical name of Fast Ethernet over fiber optic cables. It is a version of Fast Ethernet carrying data traffic at 100 Mbps (Mega bits per second) in local area networks (LAN). It was launched as the IEEE 802.3u standard in 1995.
What is 100BASE LX?
The 100BASE-LX SFP transceiver supports up to 20km link lengths over single-mode fiber (SMF) using a wavelength of 1310nm via an LC connector. Each SFP transceiver module is individually tested to be used on a series of FS switches, routers, servers, network interface card (NICs) etc.
What is 100BASE TX cable?
100BASE-TX is the predominant form of Fast Ethernet, and runs over two wire-pairs inside a category 5 or above cable. Each network segment can have a maximum cabling distance of 100 metres (328 ft). One pair is used for each direction, providing full-duplex operation with 100 Mbit/s of throughput in each direction.
What is the difference between 100BASE TX and 100BASE FX?
The 100 Base-TX cables can support data speeds up to 100 meters and must possess minimum recommended node length of 2.5 meters between two cables. 100Base FX: In FX, the cable uses two pairs of fiber to support more than 100 Mbps.
What is 1000BASE LX?
1000BASE-LX is an optical fiber Gigabit Ethernet standard specified in IEEE 802.3 Clause 38 which uses a long wavelength laser (1,270–1,355 nm), and a maximum RMS spectral width of 4 nm. 1000BASE-LX is specified to work over a distance of up to 5 km over 10 μm single-mode fiber.
What is 1000BASE CX?
1000BASE-CX is a standard used for connection with maximum distance of 25 meters. With this standard a shielded twisted pair cables must be used. Even though this is one of the oldest 1000BASE standards it is still used around the globe. 1000BASE-KX is a standard used for connectivity over Electrical Backplanes.
What does 1000BASE-SX mean?
1000Base-SX is a type of standard for implementing Gigabit Ethernet networks. The SX in 1000BaseSX stands for short, and it indicates that this version of Gigabit Ethernet is intended for use with short-wavelength transmissions over short cable runs of fiber-optic cabling.
What does TX mean in Ethernet cables?
Transmitting signals
One pair is used solely for Transmitting signals (TX). One pair is used solely for Receiving signals (RX). The remaining two pairs can be used for either RX or TX, and it’s up to both sides of the wire to negotiate which of the remaining pairs are used for what.
What is TX and FX in networking?
All CAT5 UTP cables have four pairs of cables (eight wires). 100Base-TX (sometimes called 100Base-T) uses two of the four available pairs within the UTP cable, whereas the 100Base-T4 uses all four pairs. 100Base-FX also works for speeds up to 100 Mb but uses fiber optic cable instead of UTP.