What can I use for a parts washer?
Mineral spirits are used for parts cleaning due to their ability to quickly dissolve oil, grease, dirt, grime, burnt carbon, and lubricants. The most common types of mineral spirits used in immersion parts cleaners are petroleum based.
Can you use diesel in a parts washer?
We use diesel all the time to clean bicycle parts. It’s useful because it’s so oily. If you soak parts in diesel and then just rinse them, the fuel leaves a little oil on everything and parts are overall easier to clean later and you don’t have to worry about any steel parts (most are aluminum) rusting.
Can purple power be used in parts washer?
Can Purple Power be used in a Parts Washer? Yes, you can dilute 50/50 with water. If you need a stronger cleaner, increase the Purple Power amount until desired results.
Is diesel good for cleaning parts?
Can you mix mineral spirits with diesel?
I heard from an experienced diesel mechanic that I might just need to clean out the fuel system. He recommends: run it almost out of fuel, fill the tank with 5 gals of MINERAL SPIRITS, driving it through as completely as possible, fill up tank with fresh diesel, and enjoy the like-new performance.
Is it OK to use kerosene in a parts washer?
It is common to find kerosene being used as a parts cleaner in workshops due to its low cost; however, it is not as effective when it comes to removing heavy-bearing grease. Aside from its ineffectiveness, there are many other reasons why you shouldn’t use kerosene in your parts washer: It is flammable.
Can I use simple green in my parts washer?
Simple Green Parts Washing Fluid is an aqueous based cleaning fluid formulated for use in both conventional and rotating parts washing machines that use a water based degreaser. Simple Green Parts Washer is the safe alternative to dangerous, flammable, caustic degreasers and solvents.
Can I use mineral spirits in my Harbor Freight parts washer?
I’m using mineral spirits in my Harbor Freight parts washer and this caused the pump to fail after about a month. Instead of replacing the pump with an identical replacement I decided to go with this pump and at the same time modify the parts washer to add a spin on oil filter.
What kind of cleaning fluid can I use in my pump?
This pump is intended to pump unheated metal parts cleaning solvents (classified as PJQU as described in the Gas and Oil Equipment Directory) and aqueous cleaning solutions (water-based solutions that should not be used in excess of 140°F and a maximum pH of 12.) These are typical fluids that are compatible with the pump materials.
What is the discharge on a pe-2ysa washer pump?
The PE-2YSA is equipped with a 1/4″ MNPT discharge and a 1/2″ MNPT Master Builders conduit fitting. Snap-on screen helps protect the pump from debris and extends the life of the pump. Can’t find the parts washer pump you are looking for?
What size is the discharge on a Master Builders water pump?
This pump features 1/4″ MNPT discharge with a 1/2″ MNPT Master Builders conduit fitting. This unit comes with a 6 ft. plug-less power cord.