What are Dana axles?
The Dana/Spicer Model 44 is an automotive axle manufactured by Dana Holding Corporation and is used extensively among automobile manufacturers and in the automotive aftermarket area as well. The Dana 44 was first manufactured in the 1940s and is still being manufactured today, both front and rear axle variants.
What is so special about Dana axles?
The Dana 60 axle uses u-joints that measure three inches from snap ring to snap ring. The Dana 60 has a larger ring gear, larger axle tubes, larger axle shafts, and overall is much stronger. All that extra strength, however, add a lot of weight.
How do you read Dana axle tags?
Dana Spicer B.O.M. The Bill of Material (BOM) number is used to identify Dana differentials. The BOM will identify the model number, the gear ratio, the type of differential, and all component parts. Traditional BOM’s are 6 digits followed by 1 or 2 digits and start with the numbers 60 or 61.
What is a Dana 60 axle?
The Dana 60, a heavier-duty axle than the Dana 44, was first used in the 1950s. It was the axle of choice under countless Dodge, Ford, GM, Studebaker, IH and Jeep 3/4-ton and 1-ton fullsize trucks, as well as Ramchargers and Trail Dusters with the 440ci V-8, and some heavy-duty 1/2-ton Ford and IH trucks.
Where are Dana differentials made?
Toledo
Jeeps have rolled off the assembly line in Toledo – equipped with Dana axles – since the Jeep brand launched in 1941. Today, the ever-popular Jeep Wrangler® is produced in Toledo at FCA’s state-of-the-art Toledo Assembly Complex.
Who invented the Dana axle?
Clarence Spicer
At its outset, the operation that became the Dana Corporation benefitted from two different kinds of smarts. The engineering talents came from Clarence Spicer. While still a sophomore student at Cornell University, he patented an improved universal joint in 1903.
How do I find my axle code?
Step 1 – Locate the axle code
- Locate the Safety Compliance Certification Label on the driver’s side front or rear door panel.
- Find the word AXLE under the bar code.
- Find the two-digit code under AXLE.
How do I know what Dexter axle I have?
How do I identify my axle? In the unlikely event that you should require service assistance from Dexter, please have the lot (serial) number of the axle available when you call. engraving. Recreational Vehicle axles that have been certified for use in Canada will also bear the letters CSA.
How do you tell if I have a Dana 44 or 60?
Many Dana axles have the model ID cast into the fins or centersection. Look for a “44” or “60” cast into the reinforcement ribs. The number can usually be found on the lower right side rib below the differential cover, but it may also be found on other ribs or on top of the main cast structure.
How do I know if I have a Dana 30 or Dana 44?
The quickest way to tell is to look at the top of the steering knuckles where the Front End Housing is connected to the Knuckle. On a Dana 44 Model, you will see a large castle nut threaded onto a ball joint. For Dana 30 Models, you will see a king pin cap with four bolts threaded down into the top of the knuckle.
Are Dana axles made in USA?
25, 2017 /PRNewswire/ — In support of its global growth plans, Dana Incorporated (NYSE: DAN) today inaugurated a new high-tech axle production facility in Toledo, Ohio.