How do I log into my Juniper router?

How do I log into my Juniper router?

Type 192.168. 1.1 (the most common IP for Juniper routers) in the address bar of your web browser to access the router’s web-based user interface. You should see 2 text fields where you can enter a username and a password. The default username for your Juniper router is netscreen.

How do I access NetScreen firewall?

To access your NetScreen, SSG, or ISG Firewall using the WebUI, perform the following steps:

1. Connect your Firewall device to an Ethernet port on a workstation or network hub/switch.
2. In the browser Address box, enter the Manage IP address for your Firewall device.

How do you reset a SSG 20 Juniper?

1. Using a thin, firm wire (such as a paper clip), push the pinhole for four to six seconds, and then release.
2. Wait for one-half to two seconds.
3. Push the reset pinhole again for four to six seconds.

What is the Juniper Networks ISG 2000 default password?

Note: The default User Name and Password is netscreen . Click Login .

How do I log into Juniper firewall?

Solution:

1. Connect your Juniper firewall device to an Ethernet port on a workstation or network hub/switch.
2. If this is the first time you are using the WebUI, in the browser Address box, enter the default manage IP address: 192.168.
3. From the Enter Network Password dialog box, enter your User Name and Password.
4. Click OK.

What is NetScreen firewall?

NetScreen Technologies developed ASIC-based Internet security systems and appliances that delivered high performance firewall, VPN and traffic shaping functionality to Internet data centers, e-business sites, broadband service providers and application service providers.

How do I reset my Juniper SSG 140 to factory settings?

The reset pinhole is a button that resets the device to its original default settings. To use this button, insert a stiff wire (such as a straightened paper clip) into the pinhole. See “Resetting the Device to Factory Defaults” on page 32 for more information.

How do I wipe my Juniper router?

USING THE RESET BUTTON – The config reset button functionality is available in SRX and J-Series platform on juniper reset devices. The reset Config button is available on the front panel of the SRX device. User can press this button to reset the device to its factory default configuration.

How do I access Juniper firewall via web?

1. Connect your Juniper firewall device to an Ethernet port on a workstation or network hub/switch.
2. If this is the first time you are using the WebUI, in the browser Address box, enter the default manage IP address: 192.168.
3. From the Enter Network Password dialog box, enter your User Name and Password .
4. Click OK.