Where do you put the transom on a Garmin transducer?
The transducer should be mounted as close to the center of the boat as possible. The transducer should not be mounted behind strakes, struts, fittings, water intake or discharge ports, or anything that creates air bubbles or causes the water to become turbulent.
How far should my transducer be from motor?
On boats with outboard or inboard/outboard motors, the location should be at least 15 in. (38 cm) away from the propeller.
Which way should transducer point?
The general rule of thumb is to mount the transducer to the starboard side, which is the down stroke of most single outboard boat propellers (right hand lower unit). This side produces the least amount of turbulence and is most efficient in delivering the best performance.
How do you mount a transducer to a trolling motor?
For regular down imaging and side imaging transducers, it’s almost always best to mount them on the bottom of the trolling motor, as that allows them to face straight downward under the boat. However, with a forward looking sonar, mounting the transducer on the side of the shaft is usually the best option.
Can you mount a transducer too low?
A transducer placed too low in the water will cause water to flow over the top of the transducer creating a rooster tail and creating air bubbles that will travel over the bottom of the transducer. 3) Most transducers are mounted TOO FAR from the keel of the boat.
How do I mount a transducer on the transom?
1. Position the transducer mount ➊ at the selected mounting location on the transom (page 2). 2. Align the transducer parallel with the water line ➋, and mark the center location of each hole on the transducer mount. 3. ➌Using a 5/
Where should I Mount my transom-Mount?
Select a transom-mount location while considering these guidelines for optimal performance. • Mount the transducer as close to the center of the boat as possible. • Do not mount the transducer behind strakes, struts, fittings, water intake or discharge ports, or anything that creates air bubbles or causes the water to become turbulent.
What do I need to install the transductor on my Garmin device?
aDvErTEncIa Utiliza siempre gafas de seguridad, un protector de oídos y una máscara antipolvo cuando vayas a realizar orificios, cortes o lijados. Sigue estas instrucciones para instalar adecuadamente el transductor con montaje en el espejo de popa de Garmin. Herramientas necesarias • Taladro y brocas • Llave o llave de tubo de 3/
How do you mount a trolling motor to a transducer?
Installing the Transducer on a Trolling Motor Assembling the Trolling Motor Mount Using the 8 mm M4 screws and 4 mm star washers, attach the trolling motor mount to the transducer. Route the cable through the cable exit so the cable is on the top side of the trolling motor housing when stowed.