What position should the speed control be in when adjusting the governor?
What position should the speed control be in when adjusting the governor? Rotate governor lever clockwise so that throttle is in full wide open position. Throttle stop must contact cast stop on the carburetor.
How do you adjust the governor on a 16 HP Briggs and Stratton engine?
To set the governor at its proper position, loosen the screw on the governor arm so the governor arm will turn on the governor shaft. Move the governor arm so that it stretches the spring as much as it can. Turn the slotted end of the governor shaft clock wise as far as it will go.
How does governor work on Briggs and Stratton?
When the crankshaft spins quickly, the flyweights open up, putting pressure on the governor cup and crank. This closes the throttle, limiting the air-fuel released into the engine. When the engine load increases, the crankshaft spins more slowly. This leads the flyweights to relax and the throttle to open back up.
How does the governor work on a Briggs and Stratton?
How do you fix a surging governor?
It is often possible to fix surging caused by the governor by simply adjusting the spring of the governor. Surgeries are usually corrected by only adjusting a small amount. A spring that has stretched out will need to be replaced.
How do I know if my Briggs&Stratton governor needs adjustment?
There are two main ways you can tell that your Briggs & Stratton governor may need to be adjusted. The first is if your engine is consistently running too fast or too slow. The second is if your engine surges or slows dramatically for no apparent reason. The main reason a governor could require adjustment is simply through use over time.
How does a governor work on a Briggs and Stratton engine?
The governor adjusts to changes in terrain, responding by opening or closing the throttle to allow for more or less engine power. Not only does the governor make the engine safer, but it also protects the engine, meaning your Briggs & Stratton product will work better for longer.
What happens if the engine governor is not adjusted properly?
One of the most important parts of your engine is the engine governor. An improperly adjusted governor can shorten your engine’s life. If engine speed is not controlled, the engine will destroy itself. Never run an engine over speed, especially without a load attached to it.
How do you adjust the governor on a lawn mower?
This reduces the amount of play that in the governor. To adjust the governor, a wrench and a clamp tool is required. Loosen the clamp bolt located on the governor crank until it moves easily.