What is revolver cylinder timing?

What is revolver cylinder timing?

“Timing” is a general term for the process occurring when you cock the hammer or pull the trigger in double action mode on a revolver. During this trigger movement, it presses on the DA sear — a spring-activated lever on the hammer front — which begins to cock the hammer.

Does spinning a revolver cylinder damage it?

Spinning the cylinder excessively will exaggerate the drag line from the cylinder latch. This is not damage, it’s cosmetic and usually an indication of how much the gun has been used.

What is forcing cone on revolver cylinder?

The forcing cone is the rear entrance of the barrel where the bullet transitions from the cylinder to the barrel. It protrudes into the cylinder window a little, how much varies depending on the model.

Does Smith and Wesson have a lifetime warranty?

Smith & Wesson will repair, without charge, for the lifetime of the original owner, any Smith & Wesson handgun purchased on or after February 1, 1989, and any M&P15 series rifle, that is found to have a defect in material or workmanship.

What’s the spinny part of a revolver called?

cylinder
In firearms, the cylinder is the cylindrical, rotating part of a revolver containing multiple chambers, each of which is capable of holding a single cartridge.

What is back boring a shotgun barrel?

Back Boring in layman’s terms Put simply, back boring takes a standard shotgun barrel and increases the volume. This is done by removing some of the material from within the barrel to create more space. Most of this space is created around the bore of the barrel to taper the amount of internal friction.

What are forcing cones?

The area in a shotgun barrel just in front of the chamber that directs the shot load into the bore is called the forcing cone. In most production shotguns this forcing cone is very short and at a very steep angle. We lengthen the forcing cone to 3 inches and and polish it.

What bullets do revolvers use?

Among these are the .22 rimfire, a caliber popular for target shooting and teaching novice shooters; .38 Special and .357 Magnum, known for police use; the .44 Magnum, famous from Clint Eastwood’s Dirty Harry films; and the .45 Colt, used in the Colt revolver of the Wild West.

What does a hammer do on a revolver?

Cocking the hammer rotates the cylinder. This action brings a new round into alignment with the barrel. Once cocked, the SA revolver trigger must be pressed to fire. The hammer must be re-cocked to fire another round.

https://www.youtube.com/watch?v=0c-8IySBwQ8