How long do indmar engines last?
It will depend on proper maintenance and how the motor is used (i.e. wakeboard speed vs. barefoot speed). You could expect at least 800 hrs as worst case. I have been on ski teams with boats having over 1200 hrs with no problems (and still good compression).
Who makes PCM engines?
Pleasurecraft Engine Group
About Pleasurecraft Engine Group: Pleasurecraft Engine Group, owned by Correct Craft, manufactures four engine brands, PCM, Crusader, Challenger, and Levitator, from its headquarters in Little Mountain, South Carolina.
What is considered high hours on an inboard boat?
Well-maintained inboard engines, inboard outboard engines (unless diesel), and outboards have a serviceable, average life of about 1500 – 2000 hours. If you are looking at a gas-fueled marine engine close to or exceeding 1000 hours, inboard or outboard, proceed with caution.
Who makes Indmar Marine engines?
Ford Motor Company
Ford Motor Company will re-enter the marine market in an agreement with Indmar Marine Engines, the world’s largest privately held manufacturer of gasoline inboard marine engines.
Where is indmar serial number?
engine block
The serial number is stamped on the engine block. Refer to Figure 1.1 for locations. The serial number also appears on the emissions label on the valve cover of the engine and on several stick-on tags that are attached to major engine components.
How long can the monsoon last?
The official “monsoon season” in the Southwest starts June 15 and lasts until September 30. Some residents like the break from the 100+ degree heat and the rare wonder of precipitation falling from the heavens.
How many bolts are on a 5 7 crankshaft?
Light duty 5.7L engines have two bolts per crankshaft bearing cap. the heavy duty 5.7L engines have four bolts per crankshaft bearing cap, on bearing caps 2, 3, and 4. The number five crankshaft bearing at the rear of the engine is the end thrust bearing.
How many bolts are in a 6-165 engine block?
Engine Engine Mechanical – 5.7L 6-165 2001 Marine/Industrial the engine block for proper alignment and clearances. Light duty 5.7L engines have two bolts per crankshaft bearing cap. the heavy duty 5.7L engines have four bolts per crankshaft bearing cap, on bearing caps 2, 3, and 4.
What kind of engine does a 2001 marine/industrial drive belt rumbling have?
6-22 Engine Mechanical – 5.7L Engine 2001 Marine/Industrial Drive Belt Rumbling Diagnosis Diagnostic Aids Vibration from the engine operating may cause a body component or another part of the vehicle to make rumbling noise. The drive belt(s) may have a condition that can not be seen or felt.
What kind of engine does a 490763 have?
Engine Engine Mechanical – 5.7L 6-71 2001 Marine/Industrial 490763 Important: When assembling the piston and connecting rod, the mark on the top of the piston must point to the front of the engine block.