How do I reset my transfer case control Silverado?
To reset and clear the transfer case control module, pull the five amp TCCM thread bridge at the bottom of the fuse box. Wait for at least 30 minutes and then replace the fuse. Next, turn the electric key and wait for the flashing of the 4×4 light. Turn your engine off after that.
What does a 4 wheel drive actuator do?
A 4×4 actuator is an electronic device used to engage the front differential on a so-equipped, four-wheel drive vehicle. Not all types of four-wheel drive vehicles use this type of switch.
Where is the Tccm located on 1999 Silverado?
The TCCM is located at the lower left of the instrument panel above the fuse block.
Can I drive without Transfercase motor?
Without a transfer case, you will not be able to drive the vehicle since the power is split 50/50 to the front and rear drive shafts and in 4WD or 4H mode. Alternatively 100% of the vehicle power is transferred to the rear drive shaft and differential from the transfer case when 2H mode is selected.
How does the transfer case work on a Chevy Silverado 2500?
The transfer case consists of a series of gears and chains and when switched over allows power to be transferred to the front wheels and rear wheels at the same time. In order for the transfer case to switch into four wheel drive, 4×4 mode a gear must be turned inside the transfer case. 2001-2002 Chevrolet Silverado 2500 HD 6.0L, 6.6L, 8.1L
What is a 4WD transfer case actuator?
Replacement 4WD Transfer Case Actuator – controls the switching of your vehicle in and out of 4×4 mode. If you regularly use your 4 wheel drive vehicle to navigate deep puddles or bodies of water it may accumulate moisture and corrosion.
What is an OEM 4WD transfer case shift encoder motor?
OEM Fit, Quality, Finish- The 4WD Transfer Case Shift Encoder motor is manufactured to the same specifications as the factory actuators. The actuator features a redesigned housing to insure it lasts longer than the factory part. While this is NOT a genuine OEM part, it is a direct replacement for the factory 4WD actuator.
How do you install a shift motor on a transfer case?
Make sure to attach the new detent plate in the exact same position when installing the new transfer case shift motor. First, properly align the gasket and hold it in place. Insert the bolts into the new shift motor before installation.