TheGrandParadise.com New How can I access my DVR from outside Network?

How can I access my DVR from outside Network?

16/06/202216/06/2022| Shirley GriffinShirley Griffin| 0 Comment | 12:00 AM
Categories:

How can I access my DVR from outside Network?

Please follow these setup instructions to setup remote Internet access for the dual codec JPEG DVR:

  1. Assign your DVR an IP Address.
  2. Connect to your DVR on your LAN – Local Area Network.
  3. Setting up Port Forwarding on your Router.
  4. Setting up a Static DHCP IP address for your DVR.
  5. Remote Internet Setup.

How do I set my DVR for remote viewing?

How to Remote Access a DVR

  1. Create and Configure a Dynamic DNS Account.
  2. Set Up a Dynamic DNS on the Router.
  3. Connect the MPEG-4 DVR and Locate the DVRs IP Address.
  4. Setting up a Virtual Service on the Router.
  5. Install the Remote Viewer Software for Remote Internet Access.

How do I setup my DVR remotely?

How can I watch CCTV without Internet?

The cameras and the recording NVR connect with each other via the proprietary network. By connecting the NVR to a monitor via a VGA or HDMI cable, you can get 24/7 video surveillance for your property even without Internet connection.

How to reset the password of the zicom DVR?

You can send the Serial number, Date, and Time on the DVR to the technical support ([email protected]), a temporary password will be sent, and you can then reset the password 3. What is the maximum storage capacity of the Hard Disk in the DVR?

What is the latest version of DVR configuration tool?

The latest version of DVR Configuration Tool is 1.0.11, released on 08/12/2016. It was initially added to our database on 05/06/2012. The most prevalent version is 1.0.11, which is used by 50 % of all installations.

How to port forward my DVR to DMZ?

But for this you have to port forward your DVR in your modem / router. For port forwarding you can activate DMZ in your modem & just insert LAN IP of your DVR in DMZ host then SAVE & REBOOT the modem. 12. Do I require separate Static IP for each DVR to view all the DVRs are on same LAN network?

How to configure static IP in DVR?

If you have a modem & you are using the same network for other purpose also then Static IP need not to be configured anywhere in the DVR, it is to be entered in the Internet Explorer for viewing the DVR from different network. But for this you have to port forward your DVR in your modem / router.