Why is my SonicWall not connecting?

Why is my SonicWall not connecting?

Check your browser settings to make sure the proxy is turned off (if you do not have a proxy in your LAN). Make sure you don’t have any open applications like VPN Client etc. Disable any Software Firewall or the Windows Firewall. Try different WAN Link Speed for example 10 Mbps-full duplex ,100 Mbps full duplex etc.

How do I set up SonicPoint?

Configure the existing SonicPoint profile or create a new profile.

1. Select SonicPoint.
2. Configure the default profile or select Add.
3. Configure your Wireless A and/or Wireless G Settings. From here you can change the SSID, Radio Mode, Channel, ACL Enforcement, Encryption, and advanced settings.
4. When complete, select OK.

How can I access the SonicWall management interface?

Open an Internet browser and enter 192.168. 168.168 in the address bar. As this is the first time you are accessing the SonicWall UTM management interface, you will be presented with a wizard. You could follow the wizard to set a new admin password and other information.

How do I factory reset my SonicWall?

Open a Web browser on your computer, type “192.168. 168.168” into the URL box and press “Enter.” On the SafeMode Management display, click the boot icon on the “Current Firmware with Factory Default Settings” line. This will reboot the SonicWALL to its factory settings state and you can now reconfigure as needed.

Why is SonicWall NetExtender not connecting?

NetExtender cannot connect. Navigate to Device Manager and check if the Dell SonicWALL SRA NetExtender Adapter has been installed successfully. If not, delete the adapter from the device list, reboot the machine and install NetExtender again.

Why is my VPN not reachable?

Failure to connect to the internet with a VPN is often caused by firewalls, blocked ports, outdated VPN software, or simply a failure of your router. Make sure that your firewall allows for use of the VPN, that your VPN software is updated, and that the right ports aren’t blocked.

How do I setup a guest WIFI on SonicWall?

Enable Guest Services on the LAN zone

1. Login to the SonicWall management GUI.
2. Navigate to Manage | Network | Zones page.
3. Click Configure button for the zone you wish to add Guest Services to.
4. Click Guest Services tab.
5. Enable the check box under Enable Guest Services.
6. The following additional options can be configured.

What is virtual access point?

Virtual Access Points (VAPs) segment the wireless LAN into multiple broadcast domains that are the wireless equivalent of Ethernet VLANs. VAPs simulate multiple APs in one physical AP. Each radio supports up to eight (8) VAPs. For each VAP, you can customize the security mode to control wireless client access.

How do I enable WAN on SonicWall?

Resolution

1. Navigate to Manage | Policies | Rules | Access Rules page in the SonicWall GUI.
2. Choose view style as Matrix and click on WAN to WAN matrix button.
3. Click on the Configure option of the management rules and choose the newly created or existing address object / group in the Source field of the access rule.

How do I enable RDP on SonicWall?

Navigate to Services | Policies and click on Add Policy. Select the following for the policy. Click on Accept. A group level policy to allow RDP to the same IP address.

How do I reset my SonicWall NSa?

Use a narrow, straight object, like a straightened paper clip or a toothpick, to press and hold the reset button on the back of the security appliance for five to ten seconds. The reset button is in a small hole next to the console port or next to the power supply, depending on your SonicWALL security appliance model.