What does P0010 permanent code mean?
P0010 is a generic OBD-II code indicating an issue with the engine control module (ECM) detecting a variation in the mechanical timing between the crankshaft and bank 1 camshaft. The timing issue is typically detected during higher RPMs of the engine when the ECM attempts to adjust valve lift during higher speeds.
What can cause a P0010 code?
There are many potential causes of code P0010.
- Faulty VVT control solenoid valve (most common)
- Oil sludge in the engine.
- Crankshaft position sensor malfunction.
- Camshaft position sensor malfunction.
- Frayed or damaged wiring.
- Engine operating outside of proper timing parameters.
What is a camshaft position actuator circuit Bank 1?
Code P0010 stands for “A” Camshaft Position Actuator Circuit (Bank 1). The code indicates that your car’s primary computer, which is also referred to as the powertrain control module (PCM), perceives a problem with one of the engine’s VVT solenoids.
Can I drive with a P0010 code?
In other words, a code P0010 indicates just a bit off engine timing, since the camshaft is unable to adjust the valve to get the gears to set in place the way the engine would like. In the event that your vehicle does not work properly, stop driving it while your engine gets repaired.
Should there be oil on my camshaft sensor?
It’s a normal thing for a camshaft position sensor to have oil on it. The oil is necessary for its functionality. However, the sensor housing has to be in good shape to work perfectly. A crack in the sensor housing can result in oil contamination which could make the sensor fail.
Can oil leak from camshaft position sensor?
The Camshaft position sensor can leak oil into its electrical connector causing the Check Engine light to illuminate. The engine may also stall intermittently as a result.