How do you calculate epinephrine infusion rate?

How do you calculate epinephrine infusion rate?

Using a body weight of 80 kg as an example, you can determine the infusion rate to deliver a dose of 0.1 mcg/kg/minute from a 4 mcg/mL bag as follows: Multiply 0.1 mcg/kg/minute dose by 80 kg body weight to determine dose in mcg/minute (= 8 mcg/minute).

How fast do you give EPI IV?

Adults – Start the IV epinephrine infusion at 0.1 mcg/kg/minute (range: 0.05 to 0.2 mcg/kg/minute) and increase it every two to three minutes by 0.05 mcg/kg/minute until BP and perfusion improve.

How do you give IV push to epinephrine?

Dosing. Intravenous Push/IO: 1mg epinephrine IV is given every 3-5 minutes. IV infusion for bradycardia: 1mg epinephrine is mixed with 500ml of NS or D5W. The infusion should run at 2-10 micrograms/min (titrated to effect).

How do you calculate IV infusion rate?

If you need to set this up on an IV infusion pump, use the formula, volume (mL) divided by time (min), multiplied by 60 min over 1 hour, this equals the IV flow rate in mL/hr. Using this formula, 100 mL divided by 30 min, times 60 min in 1 hr, equals 199.9, rounded to 200 mL/hr.

How is nitroglycerin infusion calculated?

Initially, 0.25 to 0.5 mcg/kg/minute continuous IV infusion. Titrate by 1 mcg/kg/minute IV every 15 to 20 minutes as tolerated. The usual dosage range is 1 to 5 mcg/kg/minute. Usual Max: 10 mcg/kg/minute ; however, rates up to 20 mcg/kg/minute have been used.

How fast do you push epinephrine in a code?

Epinephrine should be delivered IV/IO at 1 mg (which is 10 mL of 1:10,000 solution) Should be administered every 3 to 5 minutes during resuscitation. Each dose should be followed with 20 mL normal saline flush. Arm of delivery should be elevated for 10 to 20 seconds after dose delivery.

How fast do you push epinephrine in NRP?

The timeline during neonatal resuscitation for the invasive procedures of intubation or venous access is 45-60 seconds to administer the first dose of epinephrine (NRP, 2011).

When do you push epinephrine?

In the Alameda County EMS system, push dose epinephrine is in the protocol for management of shock suspected due to hypovolemia, sepsis and decreased cardiac output (i.e., cardiogenic). After empiric fluid resuscitation, 0.5 mL aliquots of 10 mcg/mL epinephrine is to be administered, titrating to SBP > 90 mmHg.

How do you calculate drip rate for paramedics?

The formula for calculating the IV flow rate (drip rate) is total volume (in mL) divided by time (in min), multiplied by the drop factor (in gtts/mL), which equals the IV flow rate in gtts/min.