How do I setup a Comfast WiFi adapter?

How do I setup a Comfast WiFi adapter?

Comfast wifi Setting Up Access Point Instructions

1. Step 1 – Connect to Wireless Network COMFAST.
2. Step 3 – Enter username admin and password admin.
3. Step 4 – Select “AP”
4. Step 5 – Set your New Network Name, Encryption Type and a new password in the Key field as below, then select “Apply”

Why is my Comfast WiFi extender not working?

If you need to reset the device to start over, just hold the Reset button on the bottom to the right of the ethernet port for 10 seconds. On a phone, tablet, or computer, search for the device’s WiFi signal and connect to it.

What is the IP address of COMFAST?

Type 192.168. 10.1 (the most common IP for COMFAST routers) in the address bar of your web browser to access the router’s web-based user interface.

What is COMFAST wireless adapter?

COMFAST USB WiFi Adapter for PC, Wireless Adapter AC1300Mbps Dual-Band Wireless Network, 2.4GHz/5.8GHz AC Built-in Antenna Network Card, Suitable for Desktop, USB3. 0 Gigabit WiFi Adapt.

What is the IP address of Comfast?

How do I use a comfast WiFi extender?

1. Plug in the Comfast WiFi Extender on your wall socket,search for the “COMFAST_****” wifi network,then click on ‘Connect’.
2. Open up a web browser and type 192.168.
3. 3.In the form, enter “admin” as user and “admin” as password.
4. Select the wireless network you want to extend and input the password of the wireless network.

How do I reset my comfast CF wr758ac?

Q: How to reset the WiFi extender? A: Press the WPS/Reset button of your extender for 10 seconds, wait to restore factory settings, when the lamp will go out and then light up again, you can begin to set up it again.

How do I use a COMFAST WiFi extender?

What’s the password for COMFAST?

The majority of COMFAST routers have a default username of admin, a default password of admin, and the default IP address of 192.168. 10.1. These COMFAST credentials are needed when doing a login to the COMFAST router’s web interface to change any settings.

How do I connect the wr300nsi to a wireless network?

Type the password for the wireless network of your router and click apply. The WR300NSI will reboot and will redirect to the user interface with the following status. e. Disconnect the Ethernet cable from WR300NSI and computer then place the device at the location, where it can get sufficient reception from your wireless router.

What are the security features of the wr300nsi?

Advanced Security WR300NSI features with 64/128-bit WEP encryption and WIFI Protected Access (WPA), WPA2 to ensure the network security and prevent unauthorized access to you network.

How to setup ComFast repeater WiFi network extender?

Step 1 – Position the Comfast Repeater beside the Network Signal Access Point ( you can re position once synced) Step 6 – You will be required to create or enter the password for security purposes, only once. Step 7 – Your WiFi Network Extender is set up, reposition as required.

How do I connect my Diamond Multimedia wr300nsi to my computer?

Diamond Multimedia| WR300NSI User Manual Page 20 of 31 Wireless Repeater a. Plug your WR300NSI to a power outlet, switch it ON and connect the Ethernet cable between your WR300NSI and Computer b.