How do I find the MAC address of my Cisco router?

How do I find the MAC address of my Cisco router?

Type “show interfaces” and press the “Enter” key to view all MAC addresses on the router. Press the “Space Bar” to scroll through the output one page at a time. Press the “Enter” key to scroll through the output one line at a time.

What is Cisco MAC address?

The MAC address is a 12-digit unique identifier needed when making an order to add, delete or change a Cisco telephone. The MAC address is printed on the bottom of each phone. You can also find the MAC address by looking at the phone information menu.

How do I find my Cisco Aironet IP address?

To find the Access Point’s IP address

1. Open utility window, make sure Get IP addr is selected in the Function box.
2. Type the Access Point’s MAC address in the Device MAC ID field.
3. Click Get IP Address.
4. Write down the Access Point’s IP address that appears in the IP Address field.

How do I enable MAC address filtering on a Cisco router?

To configure MAC filtering, follow the steps below:

1. enable.
2. configure terminal.
3. interface tenGigabitEthernet slot/subslot/port.
4. mac-addr-filter.
5. end.

Does router have MAC address?

A DHCP server (like your router) uses a MAC address to assign an IP address to a network adapter. Without MAC, an adapter can’t get an IP address. Without an IP address, the device can’t connect at all.

What is show MAC address table in router?

The MAC table is used for switching. Some routers support the ability to insert an etherswitch module into them and allow them to provide routing and switching functionality. This will be where the table is populated.

How do you write MAC address?

The MAC address is a 12 digit hexadecimal number that is most often displayed with a colon or hypen separating every two digits (an octet), making it easier to read. Example: A MAC address of 2c549188c9e3 is typically displayed as 2C:54:91:88:C9:E3 or 2c-54-91-88-c9-e3.

What is MAC filtering Cisco?

The MAC address filter enables you to restrict specified nodes from communicating with other nodes. To do this, you can specify source and destination MAC-layer Ethernet addresses to be filtered at the source (incoming) port of a switch. The MAC address to be filtered can be unicast, multicast, or broadcast.