Why my remote start is not working?
If your remote starter system isn’t working properly, try replacing the battery in your fob. You can find replacement key fob batteries at Batteries Plus. Most remote starter fobs run on 2032 lithium coin cell batteries. This one may seem obvious, but if your vehicle is not in “Park” your remote starter will not work.
Why is my Compustar remote flashing red?
*Red LED denotes 2nd Car Mode. Valet Mode: If your remote start is not working, you may be in Valet Mode. Your parking lights will also not flash.
What is valet mode on a Compustar remote start?
Valet mode is a setting in Compustar and Arctic Start systems that will shut down the alarm system and the remote starter. It will only allow the remotes to retain key-less entry to be used to lock and unlock the doors.
How do I reset my Compustar remote?
How do I reprogram my CompuStar remote to my vehicle? A: This process is outlined in the user’s manual for the remote. You must cycle the vehicle’s ignition between the on and acc/off position 5 times within 7 seconds or less and then tap the lock button, button I, or put the battery in the remote (2WSSR / P2WSSR).
How do I fix my Compustar remote starter?
Please press the LOCK or UNLOCK buttons on your Compustar/Arctic Start remote….If lock/unlock DOES NOT work – there is an issue with your remote transmitter.
- Check/replace remote batteries.
- Check the remote antenna inside of your vehicle.
- Try reprogramming your remotes.
How do I reset my CompuStar remote?
How do I reset my Compustar remote start?
Press and hold the foot brake down. While keeping your foot on the brake, press the remote start button on your remote control for 2.5-3 seconds. Your parking lights will flash once.
How do you reset the remote starter after replacing the battery?
Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.
How do I Reset my Compustar remote starter?
How do I reset my remote starter after changing the battery? Press and hold the “Lock” button on your fob remote car starter for one second. Turn your key to the “Off” position — the car lights should turn off. Do this within five seconds of turning the key to the “On” position and don’t remove the key once you’ve turned it to the “Off” position.
What would cause a remote starter to stop working?
Clicking the Key Fob Once or Twice Does Not Work.
What can cause the remote start to stop working?
The ignition is already on.
Why did my remote start stopped working?
Select Remotes&Accessories — Remote control — Connect via Bluetooth or Activate button.