Where do the wires go on a 4-prong dryer cord?

Where do the wires go on a 4-prong dryer cord?

Connect the New 4-Prong Cord Connect the white cord wire to the center neutral terminal. If your dryer has a pre-attached white wire, both wires will now be connected the neutral terminal. Connect the black cord wire to either the left or right terminal. Connect the red cord wire to the other hot terminal.

How do you hook up a dryer cord?

Instructions

1. Expose the Wire Connection Block. Locate the electrical cover plate on the back of the dryer.
2. Install the Cord. Insert the dryer cord into the hole near the terminal block.
3. Connect the Cord Wires.
4. Secure the Cord.
5. Reattach the Cover Plate.

What wires go on a 3 prong plug?

Wiring a 3 Prong Plug The power cord has a white wire, green wire, and a black wire. The white wire is connected to the silver or light colored screw, the green wire is connected to the green screw and the black wire is connected to the gold or dark colored screw.

What kind of plug does a dryer use?

The National Electrical Code currently requires 4-prong dryer outlets in all new home construction. Existing homes may still use 3-prong outlets. The switch to a 4-prong outlet was due to a flaw in the 3-prong outlet design. In a 3-prong outlet, the ground and neutral wires are contained in the same prong.

Do dryers come with power cords?

Rarely do new dryers come with power cords. For the most part, you don’t need a new power supply cord when you’re replacing an old dryer with a new one. Since most new dryers don’t come with a power cord, the appliance salesman might recommend that you purchase a new one.

Where does the green cord go on a dryer?

Some dryers have a green ground screw in a different location, to the side of the terminal block or sometimes on the dryer housing. A green screw is for the ground wire, and that is where the green ground wire of the four-prong cord is connected.

What are the colors on a 3 prong dryer cord?

Black is L1 or line one. White is neutral. And red is L2 or line two. The center wire on the three-wire cord is neutral and will always be installed in the center of the terminal block.