What board is best for shelving?

What board is best for shelving?

First and foremost, the wood you use for making bookshelves will impact the design as well as the cost of your project. ¾-inch plywood is considered the industry standard, thanks to it being strong yet inexpensive—especially when compared with some solid woods.

How thick should a shelf board be?

Plywood for shelves should be 3/4 inch thick or thicker. Standard sheets of plywood come in 1/4-inch, 3/8-inch, 1/2-inch, 5/8-inch, and 3/4-inch thicknesses. Plywood panels over 3/4 inch in thickness are usually special order products.

Can you use common board for shelves?

But, I made all of my early wood shelves using common lumber from the hardware store, like Home Depot. It’s easy, relatively inexpensive and they will cut the board to whatever length you want for free (seriously! If you didn’t know about this before, it is a serious DIY game changer).

What is the strongest shelving material?

The Best Material to Use for Closet Shelves That Will Not Bend or…

• Solid Wood. Unless you’re putting extremely heavy things on your closet shelves, solid wood should be adequate for the task.
• Plywood. Plywood is a very strong material that is resistant to both sagging and warping.
• MDF.

Is 12mm plywood OK for shelves?

Use 12mm chipboard as a minimum and support the shelf at no greater than 300mm centres for all but the lightest of loads. Or 18mm chipboard with supports no greater than 700mm apart.

What is the standard height between shelves?

Average Shelf Spacing A good average spacing for shelves is between 8 and 12 inches. If you have oversize books to store, you might prefer to increase the spacing to 15 inches.

Is plywood strong enough for a shelf?

Plywood and Composite Woods Manufactured wood products are not as strong as solid wood. Plywood is only about half as rigid as the average hardwood because it’s made of alternating layers of thick veneer. Wood is not as rigid across the grain as along the grain.

Is 9mm MDF OK for shelves?

MDF is a good material for making shelves because it’s cheaper than plywood, it’s strong enough to carry light to medium loads, it’s easy to cut to size, has a smooth surface, and paint applies well to it. Additional stiffeners and supports can be added to the MDF shelves to allow for heavier loads.

https://www.youtube.com/watch?v=wGBHpWDWvjo