How do you photocopy on HP?

How do you photocopy on HP?

From the Home screen on the printer control panel, touch the Copy icon . Swipe to the desired number of copies, or touch the keypad icon , then input a number. Touch the Settings icon , then specify the desired advanced copy settings. 2-sided: Select On or Off.

How do I reset my HP photocopy?

1 Restore Defaults

1. From the screen on your printer, navigate to Setup.
2. Tap Tools.
3. Tap Restore Defaults.
4. Tap Yes.
5. The printer will restart.
6. Once restarted, your printer will have been reset to factory default settings.

What is ID copy on HP printer?

The printer copies both sides of the ID card (or all pages of a small booklet) and prints them onto one side of a sheet of paper.

Why is my HP printer not photocopying?

Copies usually come out blank if there is a problem with your ink cartridges or the printer’s printhead. Make sure you are using genuine ink cartridges that have enough inks in them. Running a printer maintenance step like printhead cleaning should help in fixing this issue.

How do you do a front and back photocopy?

About double sided copying

1. From the home screen, select Copy.
2. Place your item face down on the glass.
3. Close the lid.
4. Select 2-Sided Copy.
5. A green tick will appear against the 2-Sided Copy selection.
6. Select Start to scan.
7. The photocopier will scan the first side.

How do I refresh my HP printer?

To restore the product to the factory-default settings, follow these steps.

1. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect.
2. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on.
3. Release the Resume button.

How do I make a photocopy of ID?

Instructions for copying an ID card Place your item in the top left corner of the glass and close the lid. Lift the copier lid, and turn your item over, placing it as before and close the lid. Select Start again to scan the other side of the card.