Can you delete a 2008 Duramax?

Can you delete a 2008 Duramax?

You can get a DPF delete pipe. It just removes the DPF section. This would be your easiest route for returning to the dealer. You can leave the lines in your factory DPF, and heat shrink wrap the harnesses on the truck to keep the road grime out of them.

Can you remove the exhaust filter on a 2008 Duramax?

This filter was installed to reduce emissions, but some owners want to remove the filter so that they can gain extra mileage or performance out of the engine. The process of removing the filter is not technically difficult, but it takes some time to do properly and it involves some heavy lifting.

Is it good to delete a Duramax?

Therefore, deleting these systems can lead to more reliability and a lower likelihood for expensive repair bills. Additionally, these systems cause a lot of backpressure in the exhaust which is bad for the turbo and causes higher EGTs. Deleting the DPF system will result in a healthier and more reliable engine.

What tuner will delete DPF Duramax?

Diesel Particulate Filter (DPF) – The EFI Live AutoCal is a DPF delete capable tuner. The DPF must be removed when installing the EFI Live.

What is the point of EGR delete?

An EGR delete helps you restore your diesel engine’s power levels which, in turn, also restores your overall fuel efficiency. Since an EGR delete kit sends the exhaust gas away from your car’s engine, it starts to run cleaner, too.

Does a 2008 Duramax have a DPF?

The DPF system and the regeneration process it undergoes is one of the LMM Duramax truck’s biggest problems. Despite the DPF system, the LMM Duramax is still a reliable and capable diesel….2008-2010 GMC Sierra & Chevy Silverado HD 6.6L LMM Duramax Specs.

How do you clean the DPF filter on a 2008 Duramax?

On the Duramax diesel engines, cleaning of the DPF happens automatically.

1. Take your Duramax-equipped truck out for an extended straight drive, such as on the highway.
2. Drive at a sustained speed for about 20 minutes.
3. Periodically engage in steady speed cruises to insure your DPF regenerates.

How much does it cost to fully delete a Duramax?

You will also need to reroute the PCV and do a blocker plate at the least. For a full delete, you will need exhaust ($400) tuning ($690) PCV reroute ($50) and Blocker Plate ($12) or new Y bridge and cold side ($700 or so). As mentioned a lift pump is a very good idea on these trucks especially the LML ($600).