Do water fountains need to be GFCI protected?
Vending machines, cord-and-plug-connected spray washers, drinking fountains, auto vacuum and tire inflation machines installed for the public require GFCI protection.
Do water pumps need to be on a GFCI?
-NEC requires GFCI protection for all pool pumps. A pool builder or electrician cannot install power to your pool pump per code without one.
How many amps does a drinking fountain use?
115 Volts, 60Hz, rated watts: 370, full load amps: 5. Perfect for either public or private settings, our stainless steel electric drinking fountains are a great fit in indoor environments.
Where is a GFCI required by code?
The NEC mandates GFCI protection in many areas of the home: bathrooms, garages, outdoor receptacles, crawl spaces, basements, kitchens and anything within six feet of a sink or water source. While that may seem like a lot, the entirety of a home is not covered.
What are the NEC requirements for GFCI protection of appliances?
Now dwelling units constructed under the NEC-2020 will require GFCI protection on any receptacle rated 125-volt through 250-volt that is installed in a GFCI-required location and connected to a single-phase branch circuit rated at 150-volts or less to ground.
What is the NEC code for GFCI?
GFCI protection is required on dwelling unit outdoor outlets* supplied by single‐phase branch circuits rated 150‐volts or less to ground, and 50‐amperes or less. NEC 210.8(F) is only applicable to readily accessible outdoor equipment outlets.
Should a sump pump be on a GFCI outlet?
You Should connect sump pumps to GFCI outlets because it prevents electrocution. GFCI is a device that trips whenever it detects a loss of current. If a malfunction allows the current to escape its predetermined path, the GFCI will protect the consumer from electrocution by shutting the power in the receptacle off.
Does code require GFCI on sump pump?
In the 2017 NEC , 620.85 did not require a single receptacle supplying a permanently installed sump pump to be GFCI protected. However, the 2020 NEC now requires a permanently installed sump pump to be GFCI-protected by an upstream device or by a single receptacle that is GFCI protected.
Do all fountains need electricity?
Water fountains don’t use a lot of electricity, but they can become pricier if you use high-end pumps. Less water and horsepower will reduce electrical consumption, but it’ll also lessen the effect of the fountain. Most water fountains cost less than $50 per month to operate several hours per day.
Do water fountains require power?
3) How much electricity will my fountain need to operate? Most fountains use around the same amount of energy as a small lamp, and you should not notice any significant increase in your electricity bill after installing your fountain. In addition, some outdoor fountains can be constructed to run on solar power.
How close can an electrical outlet be to a water source?
6 feet
According to the National Electric Code, any receptacle within 6 feet of a water source needs to be protected with a GFCI.