How long do dogtra batteries last?
The batteries in the units have an average standby life of 34-hours. With moderate nick, constant or pager use, battery life will decrease to approximately 20 hours. If the unit will be stored unused for an extended period of time, we recommend fully charging the batteries every 2 months to maintain the batteries.
How long does the dogtra 1900S battery last?
Additional Dogtra Resources:
| Manufacturer Code | 1900S-CP |
|---|---|
| Transmit Range | Up to 3/4 Mile |
| Becon Light | No |
| Correction Levels | 127 |
| Receiver Battery Life | 40-60 Hours |
How do you reset a dogtra collar?
Hold the two red dots together for about 5 seconds or more. Release them when the green LED blinks rapidly on the receiver/collar.
How do you charge a dogtra collar?
CHARGING THE BATTERIES To activate the , place the red dot on the back of the transmitter to the red dot on the collar receiver. Hold the two red dots together for a moment until the LED indicator light comes on. The indicator light will blink every two seconds showing the unit is charged and ready to use.
How long does it take to charge a dog collar?
It should take from 12-14 hours to fully charge batteries of both the transmitter and the collar. Remove the charger from the wall outlet when not in use. Batteries should be charged at room temperature.
Why is my dogtra collar flashing orange?
The color of the light indicates the status of battery life. The LED glows green when the battery is fully charged and turns to amber when battery life is getting low. When the LED emits a blinking red light, the battery needs to be recharged.
How long does dogtra collar last?
With normal use you can expect 2 or 3 days of run time from a full charge. Turning the e-collar off when not in use, a full charge can last over a week.
Why is my dog not responding to the e-collar?
Make sure your battery is charged in both the collar and the transmitter. Low battery charge can make for inconsistent functioning. Make sure both pieces are turned on and that the unit is properly synced so that the collar is receiving a signal from the transmitter.
Why is my dog care shock collar not working?
Check that the battery on the receiver collar is fully charged and replace it as needed. Verify that the transmitter has power, is on, and it’s functioning. If you have a handheld transmitter then also check it’s battery and replace it if needed. Next, confirm that the transmitter and collar are properly synced.