How do I reset my Flextherm thermostat?
If you pressed on the thermostat TEST button, the red light will come on. The test is therefore conclusive. Press the RESET button to restart the thermostat. If the red light is on and you have not pressed on the TEST button, you can press the RESET button to restart the thermostat.
How do you troubleshoot a heated floor?
Begin your troubleshooting by making sure there is voltage present at the thermostat using a noncontact voltage tester. If there is no voltage present, you have a tripped circuit breaker or blown fuse in the service panel. Reset the breaker or replace the blown fuse and recheck for power.
Why is my in floor heat not working?
This may be caused by failure of the thermostat itself, or, for example, by floor sensor failure, or simply by a tripped circuit breaker in the power panel. Users can most likely identify and correct this problem themselves, without calling a technician.
Why is my electric underfloor heating not working?
If an actuator has failed, this is most likely due to an electrical issue that could relate to the thermostat or wiring board. It’s best to consult a qualified electrician to check the circuits. A faulty actuator can also cause underfloor heating that won’t turn off and stays on constantly.
How do you detect faults in underfloor heating?
UNDERFLOOR HEATING FAULT FINDING We can detect a faulty heater by using a thermal imaging camera and specialist testing equipment which is used to locate the exact point of fault. The damaged cable or pipe is then accessed by lifting the floor for that area only and fixing the damaged heater.
Why is my underfloor heating not warm enough?
If you underfloor heating system is not reaching temperature this may be due to downward heat loss. If your heating system has been installed on an un-insulated concrete slab or over an unheated space and insulation boards were not used, there will be a considerable amount of heat loss into the sub floor.
How do I know if my underfloor heating is working properly?
When the system is running check that water is running through the flow meters on the flow manifold. If there is no water coming through the flow meters, then you have air in the system. If the pump is not running, check that the electrician has wired it in correctly (see our manual).
How many years does electric underfloor heating last?
How long will an underfloor heating system last? The pipes used for underfloor heating must have a projected lifespan of 50 years, in accordance with industry standard DIN 4726; however over 100 years is entirely possible.
What do I need to install flextherm?
According to the type of installation, either FLEXTHERM gauges or hot glue sticks, sold separately*, or an uncoupling membrane designed for heating cables. 2. FLEXTHERM thermostat and floor probe, sold separately (the floor probe is included in the box with FLEXTHERM’s thermostat).
What is included in the flextherm floor warming kit?
FLEXTHERM floor warming and heating cable kit including: heating cable(s) and installation guide. According to the type of installation, either FLEXTHERM gauges or hot glue sticks, sold separately*, or an uncoupling membrane designed for heating cables.
How to contact flextherm by phone?
Toute réclamation faite sous la couverture de cette Garantie Limitée doit être faite par écrit à l’intérieur d’une période de soixante-douze (72) heures suivant l’événement menant à cette réclamation ou l’apparition de la défectuosité à FLEXTHERM inc., 1-800-353-9843.
What is the flextherm guarantee Limitée?
CONDITIONS : Cette Garantie Limitée est applicable seulement aux Produits nouveaux et inutilisés achetés de FLEXTHERM ou de ses dépositaires autorisés, pour autant que les instructions d’installation contenues dans le guide d’installation aient été respectées.