What is Delta Force on a planter?
DeltaForce is an automated row by row downforce control system that measures and adjusts downforce every time there is variability in your field, so your crops will thrive for optimal yields.
How much down force does a planter need?
Forces Acting on the Planter This will vary based on the model of the row unit, but will typically be in the range of 150-200 pounds. In some cases, this weight alone will be enough to allow the opening disks to penetrate the soil to the depth needed for planting.
How much does Delta Force cost?
“The investment for DeltaForce is about $1,500 to $1,700 per row; vDrive would cost around $1,000 to $1,200 per row.” Because the Boenders’ planter is set up for 30-inch rows for corn and 15-inch rows for beans, it added to the cost due to the electronic structure. They chose DeltaForce for two reasons.
How much does Delta Force Cost per row?
about $1,500 to $1,700 per row
“The investment for DeltaForce is about $1,500 to $1,700 per row; vDrive would cost around $1,000 to $1,200 per row.” Because the Boenders’ planter is set up for 30-inch rows for corn and 15-inch rows for beans, it added to the cost due to the electronic structure. They chose DeltaForce for two reasons.
What is down force margin?
Down Force & Margin. Load – Weight carried on row unit depth gauging system. Margin – Amount of weight carried by row unit depth gauging system that is over and above what is required. for the openers to penetrate to full depth.
How much power does a DeltaForce planter use?
Each DeltaForce row adjusts to maintain that target. The DeltaForce system requires ~4 gpm or less of hydraulic oil to operate, and each row uses 1 amp of power. Larger planters with more accessories may require a supplemental alternator, hydraulic pump, or both.
What is DeltaForce?
Precision Planting DeltaForce is the most advanced downforce system for your planter today. It allows for individual-row weight control.
How much hydraulic oil does the DeltaForce system use?
The DeltaForce system requires ~4 gpm or less of hydraulic oil to operate, and each row uses 1 amp of power. Larger planters with more accessories may require a supplemental alternator, hydraulic pump, or both.
Why do I lose yield when I run DeltaForce?
Running a single downforce setting across an entire field causes yield loss because the setting is rarely correct. DeltaForce is an automated row by row downforce control system that measures and adjusts downforce every time there is variability in your field, so your crops will thrive for optimal yields.
https://www.youtube.com/watch?v=Y2x7KWrIhE4