How do I open my router configuration page on my computer?

How do I open my router configuration page on my computer?

In Windows 10, you can also go to Settings > Network & Internet > Status > View hardware and connection properties. The next screen displays details for your different network connections. Scan the entry for Ethernet or Wi-Fi and look for the Default Gateway setting to find your router’s IP address.

How do I change my Linksys router from 2.4 GHz to 5GHz?

Click the Wireless tab.

1. Under the Basic Wireless Settings sub-tab, select Manual.
2. NOTE: Select either the 2.4 GHz or 5 GHz band.
3. For the Linksys Wi-Fi Routers, you may enable either the 2.4 GHz or 5 GHz band, or both by setting the Network Mode to your desired standard (i.e. Mixed, Wireless-N Only, etc.).

How do I connect the Linksys wireless-N broadband router?

Linksys recommends using the Setup Wizard on the Setup CD -ROM for first-time installation of the Router. If you do not wish to run the Setup Wizard, then use the instructions in this Guide to help you connect the Router and configure it. These instructions should be all you need to get the most out of the Wireless-N Broadband Router.

How to configure DHCP client table in Linksys E-Series router?

Or, if the device is connected to your network and turned on, you can click the Administrationtab in the router’s browser-based utility, click the Local networkpage, then click DHCP Client Table. 34 Linksys E-Series Setting Up: Advanced 7. Configure Upstream Bandwidth. •To allow the router to detect the maximum, select Auto(default) .

How do I use my old Linksys E-Series router as an access point?

37 Linksys E-Series Setting Up: Advanced To use your old router as an access point: 1. With your computer connected to your old router, log into its browser- based administration utility . noTE Save your changes after finishing each step below . 2. Open the setup page for the local network (LAN) . 3.

What is the default address of my new Linksys router?

The default address of your new Linksys router is 192 .168 .1 .1 . In setting up one router behind another, you must make sure that the local network on your new router is different than the network of your upstream router .