How do you fix a jammed laminator?

How do you fix a jammed laminator?

Despite your best efforts, occasionally a jam can occur but with a bit of care it can often be resolved. If your laminator has a reverse button, you can press this straight away if the pouch appears to not be going in straight or is crinkled, this will remove the document for you to try again.

How do you take apart a laminator?

In many cases, it’s possible to remove the stuck pouch from the machine yourself.

1. Press the pouch jam lever, if your machine has one.
2. Push the “Reverse” button on the machine if you think the pouch is curled up in the rollers.
3. Pull on the laminator pouch gently if part of it has come through the front of the machine.

How do you unjam a Scotch thermal laminator?

Here’s what you should do:

1. Turn off the machine and unplug it.
2. Try to gently pull out the pouch.
3. Put the laminator in reverse mode.
4. Open the laminator.
5. Check for a release lever.
6. Open up the laminator yourself using tools.

How do you troubleshoot a laminating machine?

Can I use a heat-sealed pouch board with the Royal Sovereign laminator?

No, our heat-sealed pouch board can only be used with the Royal Sovereign EL-9DF pouch board laminator. How do I know when the laminator is heated to the correct temperature? The light either goes on or stops blinking. Please check owner’s manual for specific information on specific models. How do I clear a jam?

What is the warranty on the rollers on a Royal Sovereign laminator?

All royal sovereign laminators come with a one year warranty on parts and labor. The rollers on all royal sovereign laminators come with a 6 month warranty.

What do I do if a jam occurs in my laminator?

In the unlikely event that a jam occurs in a laminator without an anti-jamming device or you cannot locate the Owner’s Manual, please call our Customer Service Department (201) 750-1020. How do I prevent jams?

How do I order parts for my Royal Sovereign graphics product?

Contact your dealer or contact Royal Sovereign Customer support at 1-800-397-1025 or at [email protected] to order parts My finished product is curling… The possible cause for this is too much tension on the back rollers. Please contact Royal Sovereign Graphics support to troubleshoot.