Why is my Zoeller pump alarm going off?

Why is my Zoeller pump alarm going off?

This usually means your pump is not working because a) it is not receiving any or enough power or b) your pump is old, has worn out, and needs to be replaced. Your pump alarm goes off when it senses water which can also be, more rarely, that you have some sort of plumbing leak which has triggered the alarm from above.

What is a Zoeller pump alarm?

Zoeller Pump’s liquid level alarm system is useful in pump chambers, dose tanks, sump pump basins, holding tanks, lift stations, and other non-potable water applications. The alarm box is equipped with an audible and visual indicator to warn the user of a high water condition.

What happens when a sump pump alarm goes off?

The high-water alarm is designed to be an early-warning system. It’s not likely that you’ll be facing water in the basement yet, but it should be a cause for concern. Basically, when this sump pump alarm sounds, it’s telling you that there’s a problem with the pump that needs to be addressed right away.

What do I do when my sump pump alarm goes off?

Dry off the alarm and set it aside out of the reach of water. Let the pump work until it’s gotten rid of the water, and then replace the alarm. To be on the safe side, you’ll also want to call your local waterproofing specialist to make sure that your pump is operating at peak efficiency.

What is a Pak alarm system?

The “A-Pak” Alarm system sounds a horn when a potentially threatening liquid level condition occurs. The horn can be silenced, but the alarm light remains on until the condition is remedied. Once the condition is cleared, the alarm will automatically reset.

How do I turn off my sump pump alarm?

Responding to a Sump Pump Alarm

1. Check the power. If the power has shut off and you can turn it back on, go to the circuit breaker board and flip the switch to the pump a few times.
2. If the system is powered up, check the basin’s water level.
3. Inspect the sump pump alarm system.

How do I reset my sump pump alarm?

Follow these 5 simple steps to reset your sump pump:

1. Disconnect the power.
2. Take the sump pump out of the basin.
3. Clean out the sump pump.
4. Return the sump pump to the basin and restart the power.
5. Reset the sump pump.

How do you reset a Zoeller sump pump?

1. Step 1 – Disconnect the Power. Want to avoid a shocking experience – then make sure to disconnect the power before you start.
2. Step 2 – Remove the Pump. Next, remove the basin cover and take your pump out of the basin.
3. Step 3 – Clean Dirt & Debris.
4. Step 4 – Check Drain Lines.
5. Step 5 – Reconnect Everything.

What causes sump pump alarm to go off?

Your sump pump is typically out of sight but works in high-risk areas where overflows can cause excessive damage. Knowing when something is wrong with it is vital for the homeowner. To let you know something is wrong with your sump pump, the system often sets off an audible alarm.

What to do if sump pump is beeping?

The first thing to do when you hear unexpected beeping noises from the basement or crawl space is to investigate and make sure there is no flooding. After that make sure the pump alarm goes off only in the event of flooding. Sometimes a beep from the pump may mean the batteries are low in the alarm.