Why is my Aquabot pool cleaner not moving?

Why is my Aquabot pool cleaner not moving?

AQUABOT STOPS RUNNING AFTER SHORT TIME It may run for a short period after turning power off and on. The most likely problem is the timer on or in the power supply. To check, when the robot stops, unplug the robot from the transformer and check for voltage at the power transformer outlet.

How do I reset my Aquabot?

Switch the Power Supply “Off” and “On” several times, allowing approximately 30 seconds between each“ON” and “OFF”. Remember, if your Aquabot comes equipped with a Reset Switch it must be pressed each time after pressing the “ON” button. Unplug the Power Supply from the electrical outlet.

How do you change the drive belt on an Aquabot pool cleaner?

With the center pulley in the side plate, insert the metal end of the pulley into the center hole on the body, then pull the drive belts over the wheel tubes and into their respectful gear. Now fasten the side plate with screws and finish by pushing the bushings on the wheel tube and into the side plate.

Is Aquabot out of business?

2020: Fluidra/Zodiac discontinues all production of the Aquaproducts (US assembled) line of cleaners and related repair parts and closes the New Jersey factory. The remaining stock of parts is now being shipped from a third party fulfillment warehouse until supply has been exhausted.

Why are the lights on my Aquabot flashing?

What does it mean when all LED lights are blinking on the power supply? Check to see if the unit is out of water. Check to see if the filter bag is stuck in the screen. Check to see if the propellers are stuck.

Is Aquabot still in business?

How many drive belts are on an Aquabot?

NOTE CONFIGURATION -Notice how the two Drive Belts wrap around the Drive Pulley, the Stepped Sleeve Rollers, and the Wheel Tubes.

How many drive belts does an Aquabot have?

A drive motor on both sides: Two sets of belts.

What happened to Aquabot?

What is aqua bot?

We have a robotic pool cleaning solution for private pools of every type up to 15 metres long. Whether you are looking to clean the floor, floor and walls, or floor, walls and waterline, we have the right model for you. What’s more, our robotic cleaners are compatible with all pool waterproofing finishes.

Can I leave my Aquabot in pool?

It will clean for 4 hours and then turn off. The filter then needs to be cleaned out. Don’t leave it in when swimming.