What should my bike sag be?
For the rear shock – 20% – 30% sag is recommended. For the most part, this can be used across the board for trail bikes and downhill bikes. Again, keep in mind you may want more or less sag depending on your bike, weight, and riding preferences. For the front fork- 10% sag is recommended.
How much free SAG should a dirt bike have?
between 30mm and 40mm
How much free sag should there be? Free sag should be between 30mm and 40mm. If you have more than 40mm of free sag, your shock spring is too stiff. Less than 30mm and your spring is too soft.
Why is setting sag important?
sag sets your absolute vertical position along the travel stroke of the suspension. if your sag is set so that just sitting on the bike you are already bottoming out the suspension, then if you hit the slightest bump you will run out of suspension travel and the bump will not be absorbed.
How much sag is too much MTB?
You may find that your bike manufacturer recommends 33 percent sag for the rear suspension, but through testing and bracketing, you find that you prefer 27 percent. This is okay and completely normal.
What percentage is a sag?
Most manufacturers recommend that you set your sag somewhere between 25 to 35 percent. If your sag is higher or lower than that, you need to make some adjustments by attaching your shock pump and increasing or decreasing the air pressure in the shock and running the calculation again.
Is static sag or rider sag more important?
While rider sag is obviously the key measurement, static sag is just as important, especially when setting up a new bike for a particular rider as it will tell you if you have the correct spring rates installed. It can also tell you al lot about the health of your suspension.
Why is the Honda XR650L so popular?
Its tall seat height and high ground clearance appeal to off-roaders, while a reliable engine and nimble handling make it popular with road riders. Unsurprisingly, the XR650L is one of the most popular dual-sport motorcycles ever.
What is race sag on a motorcycle suspension?
SUSPENSION: SETTING THE SAG RACE SAG (WITH RIDER) 1 2 3 4 5 RACE SAG EXAMPLE The race sag is set to insure that the suspension works in its most effective rage and to keep a good chassis weight balance, front to rear. Setting your race sag is also the most important set up in affecting your bike’s overall handling traits.
Can the XR650L be mounted on the steering stem?
The steering stem is made to accept the XR650L bearings and length. The top clamp is newly designed specifically for the XR650L mounting and brackets. Custom made hand guards especially for the XR650L. Clears all cables with no interference.
What is The XR650L top clamp?
The top clamp is newly designed specifically for the XR650L mounting and brackets. Custom made hand guards especially for the XR650L. Clears all cables with no interference.