What is ablative paint?

What is ablative paint?

Ablative bottom paint, also known as self- polishing bottom paint, is softer and allows the coating to wear off at a controlled rate. Much like a bar of soap, once the boat moves in the water or there is a current and or tide, the outer layer slowly wears away.

Is Micron 66 an ablative paint?

Interlux Micron 66 is a long-lasting ablative, antifouling coating formulated to provide a level of protection not previously available in any paint. Features: Self-polishes and becomes smoother with use, reducing drag and fuel consumption.

Can you paint over ablative paint?

Ablative paint is great for boats that are used more often. You cannot put hard paint over ablative paint because the ablative paint sloughs off and will take your hard paint with it.

What is the difference between ablative and non ablative paint?

Ablative and self-polishing paint is known for being more efficient because there is a higher and longer delivery of biocide compared to hard antifouling paint. Ablating is the process of how the paint wears away after time which will prevent organisms from attaching to the hull.

How long can ablative paint stay out of water?

You should not use a hard paint if you boat comes out of the water such as on a trailer or a lift. After 72 hours, the hard bottom paint will oxidize on the outer surface from the air and becomes ineffective. If you are trailering your boat, or keep it on a lift you should always use ablative bottom paint.

Can Micron 66 be used in brackish water?

For use in salt and brackish water only.

How do you clean ablative bottom paint?

1. Don’t scrub ablative paint underwater. Modern bottom paints, either hard or ablative, already do a good job of keeping fouling away. Usually a fast run or a light sweep with a hand or soft sponge will help the paint shed any surface coating — but don’t wait too long between cleaning runs (see point No.

Will Hull cleaner remove bottom paint?

We would suggest wetting the lawn Before you apply Hull Cleaner, rinse the cleaned hull thoroughly and then wet the lawn again afterwards. Failed to get answers. Answer: Yes; Any contact with any type of cleaner can damage or otherwise remove bottom paint which is why you should not attempt to clean it.

Can you pressure wash bottom paint?

Using a pressure washer, especially of that power, will take the bottom paint off yes, but it also will cause harm to your gelcoat. The amount of working it takes to get the paint off is means there is a lot of high pressure water being forced over the gelcoat.

Can you paint over old bottom paint?

Painting Over Existing Paint If the existing bottom paint is in good condition, you may want to just recoat the bottom with a maintenance coat. Prep the hull by pressure washing the bottom. Do this or have it done, when the boat is first pulled out and any bottom slime is still soft.

https://www.youtube.com/watch?v=uCNRsaJMWoQ