Why is my Yocan Kodo blinking?
So, when you press the fire button and get blinking lights, one of two things is happening: * The cartridge center pin is recessed and not making sufficient contact, the UNI mod can’t load the cartridge correctly, and flash 5 times.
Why is my Yocan Kodo not charging?
If your Kodo device can’t charging, how to fix it? First of off, make sure use the cable is OK, please try to use this cable charge your android phone first. Due to some of cable can’t connect correctly, and can’t charge the Yocan Kodo. Then, check the indicator light status.
How do I change the voltage on Kodo?
The Kodo has three voltage levels; 2.5v, 3v, and 3.5v. You can set these once the device is already on. Once it’s on, click the firing button three times fast and it’ll cycle through each level. One LED light indicates low voltage, two lights medium, and three is high.
How do you preheat Yocan Kodo?
You can activate the Kodo vape’s preheat mode by double clicking the power button. It warms your cartridge for up to 10 seconds at a time using a low output while the LED light slowly flashes. Cancel the cycle early by pressing the button again, easy peasy.
What does it mean when my Yocan blinks 5 times?
The Yocan UNI light shut off after charged one hour, means it is fully charged. And for the blinks 5 times, means the battery can’t detect the vape cartridge.
Why is my Yocan evolve plus blinking 3 times?
Yocan Evolve Plus flashs 3 time means short-circuit error. Please try to use a q-tip clean the contact point. Or install a brand new coil or atomizer.
How long does it take for a Kodo battery to charge?
30 minutes
Somewhat making up for the lack of battery longevity is the Yocan Kodo’s fast charging speeds which allow the device to reach a full charge in just less than 30 minutes.
How do I turn on my Kodo Yocan battery?
After making sure that your battery is fully charged, turn the Yocan Kodo Box Mod Vaporizer on by clicking on the power button 5 times rapidly. Note: The power button is located at the upper portion of the battery just right below the ‘Kodo’ logo.
How does Yocan Kodo battery work?
As for operating instructions for the Yocan Kodo, clicking on the power button 5 times in rapid succession cycles the Yocan Kodo between an on and off state while 2 clicks activate its preheat function. Unfortunately there’s no draw to activate feature similar to what we’ve seen in the CCell battery.
Why is my Yocan blinking 3 times?
Three lights flash 3 times means short-circuit protection. During the manufacturing process, there can be some tolerance in extrusion on the center pin, and the UNI Mod does not have a spring-loaded center pin on the magnetic 510 adapters.
How do you use Kodo Yocan?
Press and hold the power button of the Yocan Kodo Box Mod and once the Yocan Kodo Box Mod Vaporizer creates vapors pull and draw from the mouthpiece of the cartridge. Repeat this process as necessary or until the extracts inside the cartridge is fully consumed.